Can i use a 3 way switch if I don't have but one switch in the room

There isn't room onboad for bigger batteries. But you can cheat by constructing a two wheeled trailer just big enough to hold two more batteries they can be as big as you want. When the on-board batteries get low flip a switch and your running on out-board batteries. Be sure the trailor is conntructed to be as lite weight as possible. you can buy trailers for scooter. I did it the lazy way, I wired my external batteries directly to my internal battery terminals due to amp loading.If they are lets say 50amp to your 15amp on- board batteries you are going to go way more miles than with15amp batteries. WARNING this setup you don't hook fully charged big batteries into discharged small. batteries. I don't let my on-board batteries get to discharged. I've spliced into the main battery terminal lines..so that they are thick enough to handle the amp load which are 12 gage. I also have a 50 amp connector between the external scooter and the trailer for quick disconnect

You don't find much with the door jamb switches any longer. Its all done inside the door with the switches being on the door latch.
the radio should still be able to be turned off manualy ;)

so now you can by AUTO CHARGER

Let see if I can help. The numbers don't come up so we'll just try your information.

Exhaust - should be closed when using for Air Conditioning
Energy savings turns the fan off with the compressor when set for Air Conditioning
Fan Only means just that (no Air Conditioning)
Fan speeds Quite same as low, Norm same as medium, Super same as High
Temp settings, what the thermostat senses before cycling compressor.

Is TV 2 off the 322 receiver being back fed from the receiver or do you have a direct connection to the 3rd room? If it is a direct connection, you would screw the coax from the 3rd bedroom directly to the TV 2 Home Distribution channel 21-69 out port.

If you are back feeding, you need 2 diplexers that connect 1) by the receiver and 2) between the receiver and the 3rd TV. The back feeding will use the same cable coming from the dish to the receiver.

If you have any other questions, please don't hesitate to ask.

Jane, what you really need is the Owners Manual for you discontinued model AC/Heat Pump.
Call Amana Customer Support 1-800-843-0304 and they can furnish you one. Either by email attachment or by snail mail.

Hope this helps you. Please let me know.

Hmm, I don't know why the emphasis is in the remote here.

Front panel switches still exist on most products so ramble across the room and try touching it with your finger so we don't have to factor in a possible remote malfunction.

I can't locate a free manual anywhere but YOU should contact Wharfedale and ask them where you could get one because the website only lists a handful of speaker downloads.

http://www.wharfedale.co.uk/Home/tabid/37/Default.aspx

However the digital audio for the "AV" is arriving, it is probably not syncing up or the signal / cable is failing or disconnected. Try swapping with known good cables or input jacks.

Why would you need that?

You should have some room to work,
and only 2 or 3 bolts to loosen & remove.

We don't have that, nor does a factory
service manual

Assuming you're talking about your amp is overheating, it usually means that you don't have enough room for your ventilation. You can keep it where it is, and wire a couple of computer fans from Radio Shack.You should wire them up so that they turn on with a switch. Another problem is the amp is basically out in the open, speakers could be wired incorrectly. If your amp is stable down to 4 Ohms, and you have them wired down to 2 Ohms your amp can run hot. The way to check this is to hook up a multimeter and see what Ohm load your amp is "seeing." If you don't have access to one, then just simply go to a local audio store and ask them to check that for you.

A room number preceded by a 'P' indicates the room is in privacy mode. This could be the room switch is in privacy mode, or there is a wiring issue. In this mode, the room can hear calls/pages, but you cannot hear the room from the console.
If the room cannot hear pages/calls, then you have a wiring problem.