The display panel on my kitchenaid range model kgrc608lss0 was not working so I had bought a replacement and installed it (myself). The panel seemed to be work fine however, when I try to use the oven I get and error code of F1:E3. How do I clear this ?
Try this out,
FAULT ERROR: F1 E3NOTE:Make sure harness to P1 connector is correctly installed
per wiring diagram before performing the following steps:
STEP 1 Power off and wait 5 seconds.
STEP 2 Power on and wait 5 seconds.
STEP 3 Press the following keys:
CONVECTION - CONV. BROIL CLEAN BAKED GOODS 190 TIMER SET
NON-CONVECTION - CLEAN STOP TIME 0 OVEN LIGHT 1
STEP 4 Press START.
STEP 5 Make sure Timer ID is the same as the oven.
STEP 6 Press CANCEL to exit.
What where is the P! connector ?
P1 is a connection on the control board.
Thank you. I put my glasses on and was able to locate it. It was connected properly and I followed your directions, however I still have the same error code when I try to start the oven. It appears like it wants to start the oven and then goes to f1e3 error code.
×
1,131 views
Usually answered in minutes!
×