Frigidaire Gas Self Cleaning Oven door open in lock position

there are screws in the back and then there are screws under the top on the front that are hidden by the oven door.

Could be range of problems including:

Power not connected/turned off
Ignitor ports clogged
Incorrect operation

Manual is available via Google

Press the probe button and hold for 6 seconds.
Press self clean and toggle until "continue" message appears.
Press start to accept.
good luck!

Check the Auto Timer is on Maual .

Disconnect the ribbon from the control panel and clean it using pencil eraser. then carefully reconnect it.


If the F11 is still there most likely it's the control panel.
God bless you

Make sure you keep the oven door OPEN when using the broiler, otherwise the thermostat will shut it off.

No,it will not.

Hello Frank - Since a gas range is such a complex unit and for safety and liability reasons the unit is not designed to be lift open. However you may clean the burner grates, burner caps, and the surface burner heads.

SELF CLEANINGIt is important to “Self Clean” the iron at least every two weeksto remove scale, calcium, etc. The harder the water, the more often the iron should be self cleaned.1. Set the variable steam control dial to any steam position.2. Fill the water tank up to the “MAX” level.3. Stand the iron on its heel. Plug the iron into the electrical outlet.4.Press the electronic temperature control button until you get the “MAX” temperature setting on the display panel and wait until the iron heats up and temperature setting light stops flashing.5. Turn the variable steam control dial all the way to the right to the self-cleaning position and hold the iron horizontally over the sink (Fig. 8).6. Boiling water and steam will now be ejected from the holes in the soleplate. The impurities and scale are washed away with it. 7. Move the iron back and forth as this happens.8. If there is any water left in the water tank after the iron stops steaming, just empty the remaining water in a sink following the instructions for emptying the iron. 9.Turn the variable steam control dial to the “0” position when the water tank is empty.10.Place the iron back upright on its heel to cool down before storing.