Hi
Err 7 is a motor error. You can reset the error by first unplugging the washer and then try and follow the given procedure to resolve error 7 --
- Disconnect the machine from power supply and stop the water supply as well.
- Access the back of the machine by pulling it under the counter.
- Now you’ll be able to see Phillips screws at the back panel, remove them to access the small back plate.
- Now from that opening you’ll be able to see motor and motor connector. Plug the connector back on to the motor if it is unplugged or loose. There is only way to fix it so you will not get wrong.
- Now reconnect the machine with the water supply and plug it into the power supply.
- Select only the quick wash cycle to test the machine.
After this if the error is not resolved then its an issue with the motor, and yu'll need to get it checked from a service tech.
Please do accept the solution if the issue is resolved or else revert for further assistance.
Thanks
Rylee
Hi
Thank you for your prompt reply very helpful
It looks like I will need a new machine I bet motors are expensive
Thanks again Tracey
×