Compaq armada m700 power failur...

Hi,

I'm not understanding what the problem is. If the battery is dead, and you remove it, how do you expect it to recharge? Why would you remove it? So, you take it out and nothing happens.So? What were you expecting to happen?

Before you do anything more, read the documentation that came with your laptop to learn how to care for your battery. The amber light usually blinks with the battery is running low. When you plug in the A/C adapter, the light usually becomes steady to indicate the battery is charging. At tleast until you remove it.

Hope this helps. Please rate this repsonse
Randy

Try removeing the battery form the laptop and using just AC porwer. if it still fails you may need to replace the motherboard. :(

Have you held down on the power button for more than 10 seconds to be sure the unit is off?

If not unplug power cord and remove battery if all else fails

Try this: Remove the power adapter and battery from the laptop.
Press and hold the power button for up to one minute to discharge the laptop. Try starting it.

should start charging when u plug it in leave it on it 4 5 hours then cheak status in woindows of battery ok or bios

HMMMMMMMMMMM, SOUNDS LIKE SOMEONE NEEDS A INVERTER! YOU CAN BUY ONE OF THESE ONLINE, BUT UNLESS YOU KNOW HOW TO PUT ONE IN DON'T DO IT.
CHECK TO SEE IF THE DISPLAY WORKS BY PLUGGING A VGA CORD FROM YOUR NOTEBOOK TO YOUR MONITOR IF YOUR MONITOR SHOWS WHAT YOUR NOTEBOOK IS DISPLAYING, THEN IT'S YOUR INVERTER.

remove the battery and directly connect to power and see.

the hard drive was damaged. Inside the drive, the tiny moving head took the hit. They really are not designed to take shocks like that. Many laptop mfgrs offer "industrial" duty laptops that have on-board shock absorption suspension for hard drives.

Hi Asadi Hope you doing good. Please try the following solution : 1. Disconnect the power cable. 2. Take out the battery 3. Keep holding down the power button for 60 seconds. 4. Put the battery back in. 5. Connect the power adapter 6. Make sure the Power adapter is switched on and laptop is on AC Power 7. Wait for 5 minutes and try to restart the computer 8. If it still doesn't starts. 9. Hold down the power button for 60 seconds with AC adapter and battery connected 10. Try to restart now and check. 11. If it still doesn't switch on 12. Take out the battery and run on only Ac adapter and restart. Please advise if this still doesn't helps. Regards Harry

DC Power Jack is most like defective. Typically bad/cold solder joint. Since this is a 3 state 2 prong jack, it would be best to locate and OEM Jack and replace- simply reflowing or resoldering does not always fix it. 3 State means the battery will charge with AC on and Laptop off the laptop will work with the AC on the laptop will work with the AC off and battery charged Worse case scenario an on board fuse blown (rare) Don't forget to rate me - Why? Because if I don't know if answering helps, I'll stop posting.