De- humidifier we have your machine dehumidifier FAD504TDD. we have facing problem in the machine.When we switch on the machine and adjust the humidity for 80%.The machine compressor get on.After sometime the display shows 45 and 35 and CO.The compressor goes off and the compressor never gets on again. please kindly we are looking for your advice.Waiting for your reply. Dinesh.U.A Facility Manager Arthurs food company Pvt Ltd Bangalore.Karnataka,India, Email id: [email protected]

Hi go here to download you user manual.
http://www.delonghi.com/en-gb/products/comfort/air-treatment/dehumidifiers/tasciugo-ariadry-light-dnc-65-0148112602?TabSegment=support
Have a nice day

Good Afternoon Friend, thank you for your post!

I see that your question is listed under Frigidaire dehumidifier (FAD504TDD) and that you would like to know how to remove the cover. Please help me understand if you are speaking about the bucket and if you are trying to reach the filter or the components? With this information I can provide the correct instructions to you. Thank you! - Z

Good Morning Friend,

I understand that the compressor on your Frigidaire dehumidifier, model# FAD504TDD, comes on for a second and then shuts off. First, make sure that when you are first turning your dehumidifier on that you put it in continuous mode. After about 3 days of continuous mode, set your appliance to the humidity level you would like. Secondly, the "Compressor" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. Thirdly, make sure the tank is fitted correctly otherwise your dehumidifier will not turn on. Lastly, make sure your dehumidifier has sufficient clearance to operate. There should be a minimum of 12 inches clearance around your dehumidifier. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your dehumidifier status has changed successfully. Hope this is helpful.

-Best Regards-
WP

My dehumidifier just stopped running. Plug it in and nothing happens.

There is water in the bucket or no water in the bucket? If there is water in the bucket then empty it and put it back. If there is no water in the bucket then make sure the bucket is all the way in, (there is a switch that senses the bucket). If the bucket is not all the way in the de-humidifier will not work. If you do not hear it, it is not working.

CHECK FOR THE SUPPY

I have lost my manuel. I do not know how to use the hose for when I go away for a few days.

It sounds as if the bucket full switch is broken or out of adjustment

Hi there - you have to vacuum the filter several times. You can pull it out of the back left hand side of the unit. Vacuum it several times, and then start the unit on the lower fan setting, at a humidity level of around 60%. It will kick in after a bit, and then you can start adjusting the humidity level to where you would normally use it.

Sometimes - after you have vacuumed the filter, it still doesn't work. I used my fingers to pick lint off the filter, and ran a BIC safety razor over it as well, to try and get more out of the filter. You can also wash the filter in warm water, and leave it to dry over night. Don't put it back in until it's completely dry.

This will work! Cheers... E

This model furnace does not come with a built in humidifier. Humidifiers are normally an optional add on. If you have a by-pass type humidifier it is none adjustable. Water level is normally float controlled and operation is control by blower circuit. When ever the blower runs the humidifier operates when in the heating mode.