Meter reading for a magicolor 4690mf - Konica Minolta Magicolor 4690MF Multifunction Laser Printer

Check the sensor for tray #2. Another remove the tray #2 check for broken acturator and or broken tabs that go into the machine to indicate the printer draw two is closed. Lift the printer off tray two use just one and bypass does that work eliminates the circuit board of the machine.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

yes what about it

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

ARE YOU USING GENERIC TONERS? IF YOU ARE THAN YOUR GONNA HAVE TO USE ALL GENERIC NO MIXED TONERS.

empty the old one

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Hello,

could you please tell me, how do factory reset?

Try using different USB cable.

Can you get it to print a "stand-alone-self-test" page? That page should list the capabilities and serial-number.

You use the USB port on the rear of the unit. Then install the printer drivers, see chapter 4 in the manual:

http://static.highspeedbackbone.net/pdf/Konica-Minolta-Magicolor-4690MF-Printer-Manual.pdf

Click on this link or copy and paste the complete link into your browser.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response.

Thanks, Joe

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

machine trouble 0092 service call
This happen after I cleaned the waste box for Konica Minolta Magicolor 1600W