Honeywell Chronotherm III puts heat up contrary to programming

Expose the wires and carefully put the yellow wire in with the red. See if outdoor unit kicks on.

PDF]Chronotherm III 7 Day Programmable Thermostat - Honeywell

https://customer.honeywell.com/resources/techlit/.../69.../69-0352.pdf
O I" O 0. HEAT M10 COOL OF ow to operateyo. This Owner's Guide will show you how to get the most benefit from your new thermostat. Your new Honeywell ...

To turn the fan off, press the "fan key" until it says "auto". This will turn the fan off. When the programs scheduled, changes, the fan will go on again. You have to repeat the fan to "auto" each time the schedule changes.

No. The clock is just the set back timer. Pull the battery and use the stat manually.

The problem is your 24v power source. I am unsure as to why you put "other than power source or batteries". If you did indeed check that your thermostat is receiving 24v, then I would say that you have a bad thermostat. Hope this helps

you are not geting AC power from the furnace

it sounds like it is time to repalce the stat, auto is set to allow the fan to run only when the heat or a/c is on, the switch for heat and cool will select either, and the temperature lever should allow contact for the bulbs to bring on the desired component. there are no replaceable parts on a thermostat, or I would try to walk you through replaceing them. good luck.. I prefer the honeywell vision pro or the white rodgers 9500 series stats

Hi, your replacement part can be purchased on amazon, take a look here: Amazon com honeywell chronotherm III thermostat. I hope this was helpful. Cheers

Hello.
here is a link to a website that will provide you operating instructions. Hope this helps...

http://www.hannabery.com/t8611tstat.shtml

Regards

Try this link:

http://yourhome.honeywell.com/yourhome/Applications/TechLit/TechLitSearchResults.aspx

It looks like there are a variety of model numbers for the Chronotherm III. Hopefully you can locate your model number.