Code 49 and Manual Book

faulty cold water valve, if that doesnt fix it then fault computer board

49 is a cold water valve fault. test the valve for voltage while filling, it should be recieving 24V. if not, the problem lies with the motor controller.

this code indicates a faulty main board

intuitive ECO Model IW811 display error code 49...any one can help me

Hi just read your posting.Error Code 49 means your Cold water valve is faulty,Or your control module is faulty.To test this fault you need an electrical test meter to test the water valve coil for conductivity.Have you or can you borrow a test meter to check the water valve?Please reply on how you would like to proceed and I am sure I can guide you throe the steps needed to rectify this fault.Looking forward to your reply.

it probably Needs a new cold water solenoid valve.

code 49 is a faulty cold water valve fault code. If you replaced both the valves, the wires and plugs to them are ok and it's still not working then you need to replace the Main Motor Controller module, there's no way to reset this fault sorry.

PLEASE "rate my solution" thank you.

Steve

Fault 49 usually points to the cold inlet valve, either open circuit or not connected correctly. I often come across machines that the motor controller is the problem too.

try google search for the actual model and fault code

We have an instruction manual but there are no codes.