Switch projector on, power led green, lamp led green n flashing,fan on, no lamp light, then both led's solid red, fan off. Bought new lamp and does the same thing?! HELP
SOURCE: Recently I was using my xv-z90u, I started the
There is no problem here, the sharp projectors just do this until you enter the reset procedure. It comes on a sheet with your lamp. they differ from projector to projector. often involves hold down power and some arrows while plugging in the projector - that will reset the lamp timer and you will be away!
SOURCE: I bought a new lamp for my sharp XR-11XC.
have you reset the lamp timer yet? can't remember the procedure for that one exactly often hold power and down and left arrows whilst plugging in power. Check info on instructions that came with your new lamp.
Testimonial: "Thanks, it works after reset."
SOURCE: I have the Sharp XV-z90u and we just replaced the
Or you could test it with just a burner which would be even cheaper. LumenArc sell burners individually. Your problem could be a ballast as well.
SOURCE: I have a sharp xr-10x
The bulb is trying to light but fails.
--- Please dont forget to vote this answer was helpful Many thanks ------
I would suggest you remove the bulb and check the connections are ok.
Make sure when you put it back it is in firmly.
Also while you are at it check and clean all the filters as they are often forgotten.
266 views
Usually answered in minutes!
When I say 'switch on' I mean at the wall, not on the proj' itsself.
×