TV is JVC AV 32230, I bought new remote but again only the two inch range, the range is normal for VCR and DVD
It's pretty clear that the problem is being caused by the TV's receiver, not the remote. In some sets, the receiver is on a separate small board with the IR detector and its immediate circuitry. If you can access that board (after leaving the set unplugged for at least a couple of hours), it will have an assembly part number and you might try ordering that from JVC although support for CRT sets is on the decline. Removing the rear housing isn't tough; there are perhaps a half-dozen (Phillips) screws to remove around the edge and possibly another one or two toward the center of the input panel.
100 views
Usually answered in minutes!
×