F05 fault does not load cassette properly give error F05

Hello , I have the F05 fault also ... I have changed preasure switch and have checked the pump and no blockage. It goes through half a cycle then the F05 fault comes up and flashing lights .. Question ... should the pump turn freely if you turn it with your finger ?? Mine sort of judders ... Also when you tru it on a wash it does not draw any water in ??? Can you help please ??

thanks in advance

Malcolm .

If Hotpoint or Creda,
F05: possible draining (pumping off) problem, check the pump filter, or pump, outlet pipe, or U-BEND.

Error code F05 means pressure switch jammed on full.
Remove lower rear cover of washer.
Locate and remove large black hose fastened to bottom of drum.
Remove and clean filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
This should solve the problem.
Please leave feed back.
Thankyou.

f05 is normally a fault cause by the pressure switch - often caused by a blockage in the exit hose of the washer. if the water cannot leave the washer in time the f05 will come up because the pressure switch has not told the machine it empty. on hotpoints there is a filter inside the exit pipe from the drum to the pump which gets blocked up. need to remove and clear out the sump assembly and this normally fixes the f05 error. if this does not cure the issue then the pressure switch is probably faulty but its notmally just a blocked pipe.

"F05" is a heat sensor error code. The following link explains:

http://www.fixya.com/support/r629462-f05_error_code_whirlpool_duet_kenmore

Actually, none of the error codes are included with your owner's manual. They are, however, included in the technical data sheet which should be located behind the lower kick panel directly below the door.

If you have any questions, please let me know. I hope this helps you.

this will be the motor brushes

F05 fault is the pump circuit so it is probably blocked(check all outlet hoses as well)or at worst the pcb

F05 is a water temp sensor error ,could be a bad heating element, or the temp sensor may be faulty, try checking the connection's to the temp sensor and heating element, also check the element relay.

The following link explains the "F05" error code:

http://www.fixya.com/support/r629462-f05_error_code_whirlpool_duet_kenmore

I hope you find this information helpful. I have seen this error code generated by something as simple as a loose connector on the NTC sensor. Hopefully, you can resolve this with no expense. If you do require any parts, however, you can locate parts with illustrations at searspartsdirect.com or repairclinic.com. If you require further assistance, please let me know.

Click on the following link for diagnoses and troubleshooting tips for the "F05" Error code.

http://www.fixya.com/support/r629462-f05_error_code_whirlpool_duet_kenmore

If you have questions and/or require further assistance, please post back and let me know. I hope this helps you.