I need smd ic no mp14820s it is in dsl -2640u board

this may be the datasheet still looking for other info.
https://www.grenville.com/img/products/pdfs/iR_202530_202525_20Brochure_20(Hi-res).pdf

http://www.eizoglobal.com/support/db/products/manual/S1932#tab03

You should contact EIZO about that. Also I hope that you removed that diode to test it.

Call Technical Support at 1-866-414-4714 TOLL FREE

There a great article at General Router Setup.
If you need more help post back!
Thumbs and testimonial are welcome!

Here is a direct link to show you how to secure your router, now you will need to reset your router to default settings before securing to do that press and hold the reset button located on the back of the router for 15 seconds or until router resets, you may need a paper clip to access the reset button.
http://ftp.dlink.ru/pub/ADSL/DSL-2640U/Description/DSL-2640U_B2_Manual.pdf

Please try to check up at the shops in Lamington Road.many of them specialise in SMD. if not you can order with an advance payment. Replacement of the IC must be done with the proper tool after spending so much. hence please ttry with the Maker 's service centre from the site and get a quote. Proceed if the cost is suitable or else try to get a salvage board from another damaged ( other section) model. Check this out.

i have a dlink dsl2640u when i go in 192.168.1.1 and try to turn on the wireless and save it reboots 3 to 4 times then it stays on but the wireless is off any help

(3110 out going problem) riplace mic&riplace ic

hi
it is 100m maximum