Swanstone Veritek BA-3060 alcove is shorter than the BT-3060 tub

#1 is floor level?
#2 does it wobble?
#3 check owners manual-LEVELING THE UNIT there should be adjustable 'feet' that screw into the bottom frame of the unit.some have adjustable wheels at the front.remove the vent panel under the door and look under with a flashlight to see what you have.

I am going to assume you want a way to fix the chip.

This product is a fiberglass material and can be fixed like a fiberglass car and then painted. If you have ever done this type of work it is not too bad if not then I would take it to an auto body shop and go from there. However I would get a bid from them first as it may be less money to buy a new one. The big problem will be matching the color if it is part of a complete bath combo.

If you decide to do this yourself the colors of fixture paints are very limited were as a body and paint shop can mix up any color you desire.

There is always caulking but that will always show.

Sorry but there is no easy way around this situation.

currently there are no solutions out there for plugging off the jets in a whirlpool tub.

Unfortunately Swanstone does not have a repair kit for this type of damage. The chip will be permanant. They do offer a limited lifetime warranty which if a defect is found they will repair or replace at their discretion. Of course you will be responsible for any labour cost as per their warranty and they do not go into any detail on how to repair impact damage. For more information go to www.theswancorp.com

Use clear silicone caulk

i have been installing these kind of counter tops for years,there's a ton of stuff you can buy to seal,and protect your counter, one trick is to apply mop and glow to a dry counter let it dry and apply more coats.the good thing about mop & glow is you can remove easy, it works great.good luck

Try 50:50 bleach and water with a green scrubber pad.

try tub and tile epoxy at home depot

Your sheet rock will go to the top of the lip of the tub and then your tile will overlap this lip. If it isn't done right, your grout will crack if you are tiling.

The metal bracket is applied after the tile. That is the reason for the reinforcement between the studs.