Question about JVC HD-52Z575 52" Rear Projection HDTV-Ready Television

Open Question

I have a JVC HD-52z585, have sound, but no image (even menus) on the screen. Lamp is on.

I have a JVC HD-52z585. I have sound, power and lamp led come on normally, the lamp is on, but no "image" on the screen, no menus, nothing but an illumated black screen. There is not a problem with the lamp, it is working, I am suspecting the "light engine" has gone bad that displays the image on LCOS chip?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1067 Answers

SOURCE: Blank Screen; Blinking Blue Light.

try to re seat the bulb again dont touch it lens or anything unplug ist as u do then reset timer on it ok in menu maby it just not in tight or came loose after 1st heat

Posted on Jan 21, 2008

Ad
  • 157 Answers

SOURCE: NO PICTURE OR SOUND

Hi
Usually, if the red light is flashing and you get no picture, that means that the lamp life cycle is finished and you'll have to get a replacment lamp. the lamp has about 3000 hours of life (2 to 3 years under nomal use).

You can buy a replacment lamp from here
http://cgi.ebay.com/NEW-DLP-LAMP-BULB-JVC-FOR-HD-61G787-HD-61G887-HD-61Z456_W0QQitemZ320274762989QQcmdZViewItem?IMSfp=TL0807151554r7572

Hope this helps
Cheers

Posted on Aug 10, 2008

  • 1 Answer

SOURCE: JVC HD DILA 56G886. replaced lamp and now it shuts down after 10

we found that it is an auto shut off system on the TV due to over heating. The lamp, if not cooled correctly shuts down. We added a mini fan in the back and it seems to work fine now.

Posted on Jan 25, 2009

  • 556 Answers

SOURCE: have lamp message in JVC HD-52Z585 to replace lamp #TS-CL110U.

I would, it's cheaper than replacing the whole TV and you can do it yourself so no labor bill. The new lamp usually comes with directions and in my experience the JVC lamps are outlasting some of the other ones.

Posted on Sep 10, 2009

fieldy14
  • 456 Answers

SOURCE: rapid blinking light (lamp) on a JVC model HD

It normally means the lamp is in need of being replaced, and its all depending on the use of the TV as well as how long the lamp life is. You should be able to access the lamp via a small section near the rear or the back of the TV unit, if the lamp is blown or faulty it will look the same as a blown light globe.
To obtain a new lamp contact the brands authorised repair agent as they will be able to get trade prices and in turn, give you the best price,
Also make sure that whoever replaces the lamp resets the lamp use time as the TV will still not start if you don't reset the lamp use time as it will still think it has a faulty lamp. I hope this helps, good luck.

Posted on Dec 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

JVC HD-56FN97 Alternating Power LED/Lamp LED


check the supply voltage if it is working in the ballast board, if this is a new lamp you must need to reset the lamp hour.

Aug 28, 2012 | JVC HD-56FN97 56" Television

1 Answer

Blank Screen; Blinking Blue Light.


try to re seat the bulb again dont touch it lens or anything unplug ist as u do then reset timer on it ok in menu maby it just not in tight or came loose after 1st heat

Jan 21, 2008 | JVC HD-52Z585 52" Rear Projection...

1 Answer

I have a jvc hd52z585. while watching tv it turned off and the lamp light and the power light are blinking at the same time. i have unplugged the tv for a couple of hours. when i plugged it back in it does...


very easy.
there is 1 thumb screw behind left speaker grill.unscrew it to remove the grill.the lamp is behind that.after changing the lamp,go in to CUST.MENU,scroll down to reset lamp timer. Best price for lamp is pureglare.com. Inspect the lamp for internal glass particles for 100% verification of being bad. Also at the root of the glass stem in the middle look for bubbling of the glass. This is another sign of a bad lamp.

May 20, 2011 | JVC HD-52Z585 52" Rear Projection...

1 Answer

I have a JVC-HD projection TV model 56G786 and all of a sudden it will not power on. When you try to turn it on the blue light on the power button goes on but after a few seconds it starts flashing and...


Hi,

The JVC 56G786 users manual will not give you a clear or specific answer about confirming bulb failure with the LED lamp or power indicators located on the front of the TV.

If the TV was operating normally for an extended period of time (months or years) and will not start, the problem is almost always bulb failure. If the "Lamp Replacement" warning previously appeared "On-Screen" and the TV will not start, bulb has failed.

The first step in a "no picture" situation with a JVC LCD Rear Projection TV is bulb replacement. There is no way to measure the bulb. Sometimes the bulb is visibly broken or damaged when it fails. Remove the lamp cage and have a look.

The JVC Lamp Gallery has all the JVC models and lamp numbers listed. There is also a link to DIY JVC bulb and lamp installation.

If a good bulb is installed correctly and the TV still does not start, you need a technician. There are no user serviceable parts other than the bulb. Failure of ballasts, power supply boards or controller boards is rare in these TVs.

easyab

May 05, 2011 | JVC HD-56G786 56" Rear Projection HDTV

1 Answer

Where is the projection lamp located in the jvc HD-70GC78?


hi there, I'm sure you can find it at the back casing fronting the screen. It has this box casing and you can see a glass prism. I also insert an image of JVC lamp. hope this help, please rate and vote

Mar 20, 2011 | JVC HD-70GC78 D-ILA TV

2 Answers

Have lamp message in JVC HD-52Z585 to replace lamp #TS-CL110U.


I would, it's cheaper than replacing the whole TV and you can do it yourself so no labor bill. The new lamp usually comes with directions and in my experience the JVC lamps are outlasting some of the other ones.

Sep 10, 2009 | JVC HD-61Z786 61" Rear Projection HDTV

1 Answer

JVC HD DILA 56G886. replaced lamp and now it shuts down after 10


we found that it is an auto shut off system on the TV due to over heating. The lamp, if not cooled correctly shuts down. We added a mini fan in the back and it seems to work fine now.

Jan 25, 2009 | JVC HD-56G886 56" Rear Projection HDTV

2 Answers

NO PICTURE OR SOUND


Hi
Usually, if the red light is flashing and you get no picture, that means that the lamp life cycle is finished and you'll have to get a replacment lamp. the lamp has about 3000 hours of life (2 to 3 years under nomal use).

You can buy a replacment lamp from here
http://cgi.ebay.com/NEW-DLP-LAMP-BULB-JVC-FOR-HD-61G787-HD-61G887-HD-61Z456_W0QQitemZ320274762989QQcmdZViewItem?IMSfp=TL0807151554r7572

Hope this helps
Cheers

Aug 10, 2008 | JVC HD-61Z456 Television

1 Answer

JVC HD-ILA Projection TV


From the manual...

The POWER LED
and LAMP LED are
blinking
alternately.
• It may be a malfunction that the fan is locked or the temperature has increased.
The POWER LED
and LAMP LED are
blinking rapidly
simultaneously.
• The lamp may not have been installed correctly, or it may be due to a malfunction.
• The lamp door may not be closed correctly.

The LAMP LED
continues blinking
• It may be a malfunction of the internal electrical circuits

Feb 16, 2008 | Televison & Video

Not finding what you are looking for?
JVC HD-52Z575 52" Rear Projection HDTV-Ready Television Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76140 Answers

Jaime Hernandez

Level 3 Expert

2337 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a JVC Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...