LG gas dryer not coming on - LG DLEX8377WM Front-Load Electric Dryer with 7.3 cu. ft. Capacity, 9 Drying Programs, 5 Temperature Levels, SteamFresh Cycle, Dual Humidity Sensors and Blue LCD Display, 27, Precise Temperature Control with Variable, Heat Source, Drying Rack, WrinkCare

It is a gas appliance and can only be worked on by a registered gas appliance technician. They will have access to the codes, they are generally hidden to the general public. Call for service.

The LP Conversion Kit (Part # 4948EL4002B) for the ENERGY STAR® Qualified LG - 7.3 Cu. Ft. 14-Cycle Gas Dryer with Steam - White, Model # DLGX7601WE can be ordered from any regional LG Authorized Parts Distributor. There are three regional LG Parts Distributors located in the Western, Central and Eastern regions of the U.S. To find the one closest to you, please visit us at http://www.lg.com /us/support/parts-accessories

There are two or three sensors in the heat exchanger and another one or two in the fan housing. Check them all for continuity. One in the heat exchanger is resettable

Check to make sure that the thermal fuse is not blown. Small plastic piece with 2 wires coming off of it. Typically this is problem.

Sounds like you need an ignitor part number 5318EL3001A but you will need a gas technician to work on this legally. Best off to call a reliable service company such as Sears.

The dryer has a resettable SAFETY thermostat located on the flame tube inside the dryer. LG recommends replacing the Safety and High limit thermostats if the Safety thermostat is tripped. The dryer Glow bar igniter could be bad as well as the gas valve or Main computer. Time to have the dryer serviced by a qualified LG tech. LG has factory service tech in most large cities. Give them a call at 1 800 243-0000.

Hope this helps.
Mike

defective gas vavle..replace

First, check to see if there is strong air flow out the house at the exterior dryer vent. It is very important to have good air flow for gas dryers. Second, if you do have good air flow and you do get ignition but the burner shuts down quickly and won't relight, the most likely cause is the coils on the gas valve. They heat up when current passes through them and can open up electrically. When they cool down, the process can repeat. The coils for LG gas valves are not available as separate parts. You have to order a complete gas valve, but you can then take the coils off the new valve and swap them out onto the original valve so you don't have to change out the entire valve. If you need instructions on how to get at the gas valve, let me know (with your model number).

Remember, check your air flow first !
Please rate this solution once you have completed your repair. Thanks.

sounds like the heat sensor on side of heater pan is bad and needs to be replaced ,,, its mounted on side of pan the flame blows into and has 2 wires plugged onto it / larry

If your vent is clear (strong flow of air at vent outlet outside) then you have a bad gas valve. I have seen this a few times on LG gas dryers. You really only need one of the coils on the gas valve, but they are not available individually. You have to get the entire valve.