SOURCE: 2500 pressure washer 2.3, its
Check he screen where the hose screws in. There is a screen inside the fitting you should clean. Take it out carefully by using a screw driver around the edges and make sure the screen is clean. After you put the screen back in take the hose off the gun and see if water comes out of the hose. If it does you have to take the gun apart and clean it.
SOURCE: modeL 580752610 CRAFTSMAN 2600PSI
This is the typical problem when the water admitance valve sticks. This valve admits more water to the pump when the pressure drops when wand is triggered. When pressure increases, water is blocked. This is the way they regulate the pressure. The valve is in a bore, usually crossways to the axis of the shaft of the pump. Disassemble the valve noting how the parts go in. Clean the bore with crocus cloth on a dowel rod. Replace all the O rings on the valve spool. Lightly lube the spool with plumber's grease and reassemble.... Good as new! You can often buy a kit of O rings for the valve. They must be EXACT right size. This is normally a one-half hour job.
1,418 views
Usually answered in minutes!
×