Question about MagLite Mag-Lite& Flashlight
I have a two AA cell mini maglite. The battery housing is at the end of the maglite opposite of the lamp end. The end cap will not unscrew so I can replace the dead batteries. Any tips on how to remove the end cap? We tried running under hot water and spraying on WD-40 with no success.
With all of the views on this problem, you would think that MagLight would
come up with a solution. I personally have had this happen to 2 different
flashlights. Never again will I purchase a Maglight!
Posted on Aug 09, 2012
I applied a solvent (liquid wrench) overnight, and with a rod in the lanyard hole and vice clamp pliers, was able to remove the cap. But now I'm challenged with removing the corroded batteries so that I can get the battery manufacturer to replace the flashlight....I wish I knew, and had proof of what batteries are in there.
Posted on Jul 27, 2010
I had luck using dental floss. I slid it between the joints and "flossed it" a bit, then unscrewed!
Posted on Mar 15, 2013
I was able finally to open the end with two sets of pliars after wrapping it with a rubber cloth to prevent scratching I got it open, but the batteries (at least the top one) was corroded and they wouldn't come out. I poked and prodded around the circular edge to remove a little of the corrosion, but they still wouldn't come out. I boiled a little water, put some in a tall strong glass, only about an inch or two, added baking soda (stirred) and stood the BATTERY END in the water for only about 5 minutes. I then banged it against the side of my counter and both batteries fell out to the floor! I dried the inside, put in two new batteries, put a little vaseline on the screw end threads and everything works great! Yippeee...
Posted on Aug 08, 2017
I put on WD-40, then used 2 vise grips & tried to twist it open but it wouldn't budge, so I put it through a table vise with cap upside, tightened vise and twisted hand grip to open and it worked. Then I wire brushed the cap and put the flashlight standing upright into a pot of boiling water with a teaspoonful of baking soda in it and left it soaking for 3 hours to dissolve the corrosion inside the battery compartment hoping to loosen the batteries inside. Haven't checked it yet but am hoping it a
Posted on Mar 18, 2015
I slipped an allen wrench into the hole for the lanyard and was able to unscrew it fairly easily. It was stuck because the batteries were severely corroded but I've had the thing for six or seven years so that's not a surprise. I should make a note to change the batteries every year or two.
Posted on Dec 14, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 23, 2017 | MagLite Camping, Backpacking & Hiking
on Jan 12, 2011 | Kitchen Appliances - Others
Aug 19, 2016 | Camping, Backpacking & Hiking
Nov 14, 2010 | MagLite Mag-Lite& Flashlight
Jun 30, 2010 | MagLite Mag-Lite& Flashlight
May 26, 2010 | MagLite Mag Lite Led 2 Cell Aa Flashlight...
Jun 18, 2009 | MagLite Mag Lite Led 2 Cell Aa Flashlight...
Jun 02, 2009 | MagLite Mag Lite Led 2 Cell Aa Flashlight...
46,904 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: