The plastic peg that attaches the deli drawer lid to the refrigerator wall broke off. I can see no way to fix it. The peg seems to be part of the fridge wall. It goes into a hole in the lid. Designers should had made it the other way around, so that if the peg breaks off, a new lid will fix the problem. I don't know what to do.

I would remove the track, clean both surfaces and stick it with clear silicone or superglue Gel. Leave it 24 hours to set.

Call in a repair man, it shouldn't cost that much. Yes, your food will be effected without that plastic door, as the drawer has controls and cold settings just for deli items. You need a special glue for cold. I'd call in a repair man, or order a new drawer replacement from the manufacturer.

Hello friend, thanks for your inquiry!

I understand that you have a Frigidaire refrigerator, FGHN2866PF1, and your deli drawer is freezing items. You may want to turn down the temperature within your deli drawer, when adjusting the temperature could take 24 hours for your refrigerator to stabilize. If that does not resolve your issue I would suggest removing the drawer and checking over to make sure there are no cracks where too much air may be coming in. If there is too much weight in the deli drawer that could cause the drawer to sag, which may release cold air into the deli drawer. I hope this information has been helpfu. -Matt

Try searching w/ Google on the brand and model no.

Here's one possibility: Parts

I would direct you to this link to find the part number you're looking for. I do not have one of these units to look at so am unsure which specific piece you'll need to replace.
Model 59673503200 KENMORE ELITE KENMORE REFRIGERATOR Parts

Hello, Thank You for using FixYa. I will be helping you today.It has to be replaced..You have to call maytag to have a factory tech come out to replace it and it will be covered under warranty.
Thank You and please rate my answer if it was helpful..

The wider end of the piece can be hooked anywhere on the back of the deli drawer. Keep the piece bent when you install it or it will scratch the glass on the front of the drawer. Also, make sure the tip of the smaller end is touching the bottom of the drawer before straightening the divider.

Hi,

Yes, that is not that hard to fix and you can easily buy the parts yourself online...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

heatman101

Hi -
And I broke off the peg on the right side and have the same question. Any luck/answers?

If that piece broke, you may need to replace that part, I wouldn't recommend any gluing.