The Refrigerator side is warm, and the freezer side is not making enough ice,and the ice is not solid

SOURCE: freezer doesn't cool, refrigerator is startin to warm up

There can be several reasons to it.
1.Dust collection can create such a thing but it does not happen directly you should understand the performance loss with in time.
2.Gas leakeage in the cooling circuit.(You need a technican to correct it)It happens due to corrosion.
3.Compressor failure.(This is really a small percentage)
4.If this is a no frost appliance not properly closed door.Make the evap blocked.You can unload the appliance.unplug wait for a day then start again.

SOURCE: ice maker not making ice

If your ice maker has stopped producing ice completely, check these, in this order:

• It may be turned off. Look for the wire along the right side of the ice maker that looks a bit like a coat hanger. If the wire is in the raised position, the ice maker is turned off. If so, try one of these:
  
  
  • If your ice maker has a small red plastic lever, lower it to lower the wire.
    
    
  • If there's no plastic lever, simply lower the wire.
    
    
  In either case, the ice maker should begin producing ice again. Also make sure that the temperature is 8 degrees Fahrenheit or lower. If the freezer is too warm, the ice maker won't cycle properly.
  
  
• The ice maker fill tube may be blocked with ice. If so, melt the blockage using a hair dryer-but be careful to not melt any plastic parts! Also replace the water shut-off valve or water-inlet valve, or both, if necessary.
  
  
• The ice maker head assembly may have broken parts. Look to see if the gears are broken. Check to see if the small plastic arms that rest against the ice rake are broken. If the ice maker head assembly is modular and you've found broken parts, you can just replace it.
  

Northeast Cooling LLC

• 122 Answers
• Posted on Oct 29, 2009

SOURCE: model no 253.5711860 side by side the freezer will

The board will not fix the problem if the heater or the hi temp limit is bad. It sounds like the "computer" is not the problem. Have someone come out and diagnose the problem.