Help pairing my H12 bluetooth

Try pairing again.

TX550 Bond Pair

Be sure Bluetootis enable on your iPhone when you search for your tx550.

Mark
Motorola Support

Hi there,
The easiest way to find this information out would be to go on the Motorola interactive bluetooth pairing simulator: Motorola pairing simulator
This will ask what headset you have, and I've noticed the H12 is in a section titled "existing products", it's just a fraction down from the top of the webpage when it opens.
You will then be asked which phone make and model you have.
This will then take you to a very helpful interactive page which will walk you through the pairing process step by step.
I hope this helps.
Warm regards and a Merry christmas.
Mike

http://www.google.com/search?hl=en&q=h12+manual&aq=f&oq=&aqi=

turn your bluetooth on and on your phone go to bluetooh or settings(if not under bluetooth) and select trusted devices or pair devices, then on the left or right corner it will say (search) once you have found your bluetooth it will say(motopure h12) select and then it will say pair device and you put in the code that came and your instructions and your good to go.

My H12 manual has the passcode as 4 zero's for most phones.

I just kepted trying the 0000 and it finally worked. Thanks for trying to help me. Debra

Yes I would think that the unit is bad. If it is paire and you see volume level then there should be sound.

Hi,

Had the same problem myself try 0000 it seems to be the standard motorola solution for H12 bluetooth headsets. good luck

I think you have to put in 000000 six zero's try that.

-put the headset in the covered charger (not plugged in)
-hold down all 3 buttons for at least 10 sec
-leave headset in charger (unplugged) and enter in 0000 when prompted for pin.