Toshiba 3387db has stopped working

Yes!

they may not be supported in the DVD you are currently playing. Try cycling through the differedt modes. STEREO, MOVIES, GAMES ETC

One thing to remember about most radios, the RCA pre amp circuit will still work even if the mosfet power amp inside the radio does not. The best way to know if the amp inside the radio works is to use one matching color pair coming off the radio to wire up a random speaker right to the radio. You can use just about any old random 4 ohm speaker that is laying around to check it. The best solution if the amp inside the radio is blown is to replace the radio or amp the pre amp outputs with a small 4 channel amp. Oh, by the way. What vehicle are you connecting this into? And does the vehicle say Bose, Infinity, or ect sound or Premium sound? These usually denote a factory amplifyer already onboard and requires special connections to get the signal to these amps to then be delivered to the speakers.

This condition sounds normal, often you need to turn off the speakers in the TV, via menu options on the TV.

You need to convert the component sync signals into a composite sync compatible with SCART. The red, green and blue signals can be connected through as-is.

Beano did you get a solution for this? as I'm encountering the same problem

Something isn't wired correctly, check you wiring and get back to me.

Hi,

Did you turn the bluetooth on and put the phone in discovery mode before attempting to receive something via bluetooth?

it is due to 60Hz HUM IN POWER SUPPLY. please check for input supply. also check for mains filter capacitor in tv. also check for one diode open in rectifier ckt.

1)probable incompatibility issue--for comparison did you try a set of headphones? 2)The RCA audio outputs on the tv can go to an amplifier that has speakers attached,ie surround sound. 3)Caution==never try to alter vol level at spkr!