Ranger rci 2950 will not transmit

get hold of ranger and they should be able to help you.

hmmm my money is on a cold or several cold solder points,,
start checking the legs on the PLL first...

i have the same radio rci 2950. Ive had the same problem with mine,turns out with mine the processor would lock up,turning the radio off & on repeadly would clear the problem and the radio would work fine x-mit & recieve. the solution to fixing the problem is to replace the memory backup battery this battery works similar to a computer motherboard cmos battery when this battery goes dead all sorts of strange things happen to the radio wont transmit wont recieve or like your problem transmits continiously. the problem with replacing this battery is finding out what year & model your ranger 2950 is. the internet says only first generation ranger 2950s use the battery second genration & third generation do not use the battery. but the internet could be wrong. so i suggest getting a hold of (usa ranger.com) & give them a phone call or email and ask them about the year your radio was made. they may even service it for you or if you are electronic savvy you can do it yourself. the battery is located close to the main cpu on the front panel if yours uses a battery.

You either have a bad LCD display OR the connection for the LCD display is loose/off. Its impossible to tell what channel you are on with a 2950 without the screen working, but when you turn the channel knob do you hear any other cb transmitting on ANY channel?? This is a tough one!! I really need some more info on the radio.

Open the case and look at the area that the display is in (front of radio). Slightly wiggle all of the little plugs in that area. If you see the LCD screen come on or flash then you know where your problem lies. If not, then you're probably looking at buying a LCD display for the radio.

Good luck.

If it was working fine before storage it is most likely electrolytic capacitors. These "can" looking things that are all over the circuit board. These little cans are filled with electrolyte like a battery. If this leaks out or evaporated as they are known to do they will render useless or degrade circuit voltage and current in circuit.

could be a number of different problems causing this. I would start with your microphone make sure it is working. it is responsible for transmit & recieve. next check to see if the memory battery is dead this will also cause this problem. next check the regulators in the radio to see if they are supplying voltage.next check voltages in different parts of radio to see if all stages are recieving power follow these steps and something will show up also check your switching diodes to see if they are bad the diodes responsible for x-mit & r-mit of transceiver.

hi tell me

check the ground wires

http://www.rangerusa.com/websupport.html

http://www.worldwidedx.com/cb-band-cb-radios/18036-manual-rci-2990-a.html

you may find some help with these sites

replace memory battery its a CR2032 battery Radio Shack and Walmart has them from $3.65 to $5 in price.