What is the impedance of the JAMO A3SUB.3 speaker?

Hello i am from outside the States but i know any KLIPSCH service center is maybe the place for JAMO or they know for sure where you should be in your Country.
Jamo About Jamo About

the easiest solution is to get yourself a cord that switches from headphone plug to RCA and connect it that way. I sure hope that this helps you in hooking your ipad up to the Jamo 200 Sub. Thanks, Cody

Hi, it is available ,but you will have to pay for it before you can download the service manual..


http://nitrodownloads.net/search/jamo%2Ba3sub.5%2Bspeaker%2Bservice%2Bmanual

Take care.

Did you get a manual with it? According to the Sony site this speaker originates in Sony MHC-GX450.

"This product bundle includes the following models:
HCD-GX450 - STEREO MINI SYSTEM
RM-SC3 - REMOTE CONTROL for Shelf Mini Systems
SSRG444 - FRONT SPEAKER FOR MHCGX450
SS-WG450 - SUBWOOFER FOR MHCGX450"


Find the manual here and learn a bit about your seprated sub...

http://esupport.sony.com/US/perl/model-documents.pl?mdl=MHCGX450

See page 7.

As can be seen, the subwoofer has two connections to the mothership, very unlike the standard speaker level (+/-) speaker wire or RCA-Line-Level subwoofer out that 'normal passive or active subwoofers use, respectively.

Not knowing which of those your unspecified Pioneer receiver supports, it is impossible to say. Does your Pioneer have that control jack?

Mini-systems are generally not designed to be pieced out and used with grown-up gear. The absence of standardized connections is the clue.

hi,
it will not be a perfect mach. u have to purchase a speaker with long term power handling capacity of 150W and 4 ohms impedance.
ok

For PC music ( I suppose mainly mp3) you don't need any extra-quality amp, any older Yamaha stereo amp will do. I don't know which of them are available in stores near you, but if you write some model numbers I can check their specs and advise more.
If your PC has spdif output (coax or optical) go for amp which has digital input available.

If you are using the amp at moderate listening levels I would say that either setting would be fine, but I would probably go with 4 ohms. It's a little high, but it is loaded and fairly close to what it wants.

Dual Voice-Coil
The unique Dual Voice-Coil design allows both left and right channel sound from just one speaker. Simply hook up both the left and the right channels to the special terminals on the speaker. Hook up one channel only, if the speaker is to be used in a conventional stereo set-up.
I found this on jamo site hope that will help you

check all your plus sign and minus sign that connected to the receiver , if connected wrong you will not have any bass,because it going backward. Good luck!! any quest email me [email protected]