Showing LL error code

i have the LL.L error in my sensor, i noticed it was disconnected, i soldered the foot and now it works.

Hello, the beeping is actually a fault code, ie short beep, long beep etc, a bit like morse code. You can get a list of what these codes mean if you google 'bios beep codes' . It means your bios has detected a basic error with the hardware and is trying to tell you what's wrong! It could be anything from memory gone bad to faulty graphics card or keyboad error, you'll have to look at the list and try to equate the codes to what you're hearing from your system. Regards, nicam49

There is no error code 4
The unit is probably set at 4 hours operation.
To change it turn unit off then back on
Now press and hold up arrow ti'll the unit beeps
now press and hold down arrow ti'll unit beeps again
Now either quickly press the up arrow or down arrow until you get the hours of operation you desire
once you have the hours flashing simply re-peat the long holding of the up arrow ti'll it beeps and down again ti'll it beeps once the beep then the # will quit flashing wait 10 minutes or so for chlorine generator to start

HMMMM dis usually comes when there is a falt i your camera . da beep meanss there is an error usually .i think your camera lens is stuck.... and it wont even budge if there is da slightest friction , take it to a repair shop or service personnel

LL = Lareg Load Detected.

I think you may have some drive system resistance/binding. This can be difficult error code to troubleshoot with knowing more info.

What was in the wash basket that caused the LL error code?

Have you tried to power cycle the washer (remove 120VAC line Cord then plug back in)?

Any unballance error codes like dc or UC in the past.

Hi


Thanks for using FixYa. Error F2-E0 in your Whirlpool range indicates shorted keypad. To resolve this issue you’ll have to replace the electronic range control (ERC). Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

we need to replace the throttle potentiometer falt.
should cost around 150. easy to replace. [email protected]

replace the toner cartiage

i have got an zanussi des 959 and showing falt code 5 could u help me out