HP Officejet 7410 All-in-One Error Message

The surge has blown up the chipset that produces the signals required for faxes.

If you have a surge protector fitted then the maker should repair or replace the printer under their terms of warranty.

If they sell you protection then they have to offer it

The error code cannot be resolved as it has to do with the hardware of the machine. The machine's hardware is mulfuinctioning.

Hi, 


Please follow the follwoing steps, 

1) unplug the power cord at the both ends from the printer and wall outlet. connect to wall out let directly dont connect to 
printer.
2)Press and hold # and 6 while reconnecting the power cord to the product hold for 1 min after plugging the power cord, and 
then release both buttons, this should resolve the issue.

Regards,  raj_p5983

There is not a lot of info around concerning this error message.

One similar problem on fixya:

Click here

If it doesn't work you should try to contact HP on their

HP support site

Hope that helps

Critter

reinstall

Hi pilchuck3,
please click on following link and which will help to how to access the ECM (Error Correction Mode), Please turned it off and i thing your issue should be resolved,
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00313088&cc=us&dlc=en&lc=en&jumpid=reg_R1002_USEN


Regards,  raj_p5983

You may need to copy and paste these links into your browser:
Here is a link relating to clearing the paper jam error message:
http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&cc=us&docname=c00743863&dlc=en&product=1119598

Here is a lik on how to do a power reset when all the lights are flashing.
http://h10025.www1.hp.com/ewfrf/wc/document?cc=us&docname=c01059445&dlc=en&lc=en&jumpid=reg_R1002_USEN

Joe
Please remember to rate Techs who assist you for free :)

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

sir i hve printer of hp 5610 all in one error come error no 0xd0620130 and all light blink. so pls ive me solutions

The product displays an 0x ... error code when printing (for example Error: 0xf0af8004 ). These error codes indicate that the product has an internal condition. Solution Use the instructions below to resolve the issue by restarting the product.

1. Disconnect the Universal Serial Bus (USB) cable from the back of the product, but leave the product turned on.
2. Open the cover of the product and remove the print cartridges.
3. Close the cover and wait for the Insert Ink Cartridges message to display.
4. Disconnect the power cord from the back of the product and wait for one minute.
5. Reconnect the power cord. If the product does not automatically turn on, press the Power button.
6. Open the cover and reinsert the print cartridges.
7. Close the cover. If prompted, print a calibration page.
8. Reconnect the USB cable, and try to print a print job from the computer.

If these steps did not resolve the issue, contact HP technical support for assistance.

http://h10061.www1.hp.com/ccsearch/search?cc=us&lc=en&dlc=en&sni=391194&opname=HP+Officejet+7410+All-in-One&pname=HP+Officejet+7410+All-in-One

copy and paste the above link into your address bar and search for the answers.