HP 8510 P FINGER PRINT SOFTWARE - HP Compaq 8510p Notebook

If you have replaced multiple components in your Brother 8510 printer, including the oven unit, laser unit, high voltage board, power board, and drum unit, but are still experiencing faded images, there are a few other potential causes and solutions to consider:
1. Toner Cartridge: Ensure that you are using a genuine and compatible toner cartridge for your Brother 8510. Low-quality or incompatible toner cartridges can result in poor print quality. Try replacing the toner cartridge with a new, genuine Brother cartridge to see if it resolves the issue.
2. Toner Density Settings: Check the toner density settings in the printer's software or control panel. If the density is set too low, it can result in faded or light printouts. Increase the toner density setting to see if it improves the print quality.
3. Cleaning the Corona Wire: The corona wire is responsible for transferring the toner to the paper. If it is dirty or contaminated, it can cause faded prints. Consult your printer's manual for instructions on how to clean the corona wire properly. Be careful when handling the corona wire as it is delicate.
4. Print Settings: Check the print settings on your computer or within the printer's software. Ensure that you are using the appropriate print quality settings and that any power-saving modes are disabled. Adjusting the print settings to a higher quality mode can enhance the print quality.
5. Contact Brother Support: If you have exhausted all the troubleshooting steps and the issue persists, it may be beneficial to reach out to Brother customer support or a qualified printer technician. They can provide further guidance or arrange for a professional inspection and repair of your printer.
Remember to follow the manufacturer's guidelines and safety precautions when working with printers and their components.

Make sure that your output is selected to stereo and not SPDIF.

Tony

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

Please check the finger print device in the Control Panel. Also, the finger print software.

JAI UN PROBLEME AU PLOTWAVE 300 MARQUE OCE
CODE ERREUR 8510
C QUOI LE PROBLEME ET C DU A QUOI ET QUESQUE JE DOIT CHANGER
MERCI
REPONDEZ PAR EMAIL
[email protected]

Log onto machine as local administrator
Launch HP ProtectTools Security Manager for Administrators
Bios Configuration -> Security
Fingerprint Reset on Reboot - Enable.
Reboot
Esc for Bios Setup
Choose Bios Option

Press F1 accept a reset of the password .

yes offcourse, to use finger print security you should have a finger print reader software
if you not have this go to acer website and download it.
after installing this you should configure yourself information in software and no one can run your machine without your permission.
thankx

For power on password issue in HP NOTEBOOKS, you need to send the NB in for Repair.

Plz install Hp 8510 Driver Install Or Chek Your Test Print

Enjoy...

More Detail
Call Me 9974892930

Try restoring the system to a previous DATE prior to your issue. START--ALL PROGRAMS--ACCESSORIES--SYSTEM TOOLS--SYSTEM RESTORE....RESTORE MY SYSTEM TO AN EARLIER TIME....select THE DATE your software was OK and then NEXT.

http://www.emtcompany.com/products/adapters/dxubdb9-usb-to-serial-db9-adapter-cable.htm?gclid=CNOZ8YLT_ZgCFQ0NDQodLEROlg