RCA Projection TV not working properly

double vision? is this multicolored. red green blue? is the picture bowed. Have you tried going to setup in customer menu and adjusting convergence, Both manual and autoconvergence.

replace box in side tv, about a size of a cell phone,may little bigger than that the. cost for the part is about $200.00 or it call the moduler,tv can replace, if you move the tv, make sure u undo the wires 1s ,, why u ask some of these wire don't bend and brakes the box, it cracks,,it ,, that what the picture don't look correct, it looks like a bow and double view

Convergence is out, need convergence board repaired, usually bad stks, 392-110s

The convergence ICs need replaced and likely several resistors in that circuit.

This is a common problem on this model. Call in a shop or do it yourself with parts and instructions from www.TvRepairKits.com

Replace Both STK convergence ICs will have part number on them STK392-560 use same part number on your STKs. Also around ICs ck pico fuses 5/6amps they are green or yellow.

Replace Both of your STK ICs convergence ICs STK392-110 use 150s Better ICs Call Mats 1-800-628-1118 Also RK42 RK46 RK48 RK50 RK54 RK58 RK60 will have to get back to you on resistor values

Conversion problem most likely. Do your conversion controls work both colors in all 4 directions.

bad convergence ic's
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html

your convergence alignment is off,requires reaignment or possible replacement of module,this type of rca projection tv has a fault with the harness feeding the convergence module there is a fix for it,contact you local rca dealer,they must replace the connector because it bows and looses connection over time that creates other faults also/