Building instructions for the ultimate 120 bipe

Check with TV repair.com who sells kits for most of these sets that come with all the needed parts and instructions---you might also look on You Tube who has video instructions for a lot.

This is a older set and the chips will either be on large board to left as seen from rear or to the far right side as seen from rear--the chips are soldered in STK-392-110 OR -120 CHIPS. I can give general instructions if know where they are and what number is printed on the front of them.

most art kits are designed to take a 35/40 engine hope this helps

are you pose to have 1 spring or two spring in robotron x

No its not normal but I have to admit Ive never seen this before and Ive been working on TV's since they were vacuum tube sets

Hello,
Try to inspect and see if all light bulbs are screwed well in place :)

Try this link below.

http://www.horizonhobby.com/ProdInfo/Files/HAN2845_PTS_ARF_Manual.pdf

Good Luck

you need to set the cam up with msn
follow the instructions please let me know if you still have problems then we can try something else. if it solves then don't forget to rate me
thanx


After you start Windows Live Messenger,
expand the view by clicking on the square
on top left next to the red X.
Then on the Windows Live messenger window on the
right side, click on “ “Show Menus.” And then click
on “Show the Menu Bar”.
Next go to the Menu Bar on right side, click on Action.
Go to “TOOLS” and click “Audio and Video Setting
and follow the instructions.

There's some manuals on this website. Not specific to your 120 bipe 55, but other bipe planes. Check them out an see if they help =>

http://www.hobbypeople.net/specials/manuals.asp

I downloaded the instruction book from Uniden and then was able to solve my problem.

Youre convergence Ics need to be replaced. Use STK392-120 Ics you will need to replace both of them. You can get replacements at the following link and they provide free instalation instructions with pics.
http://servicemanuals.vstore.ca/