How do I sync other cameras to the baby monitor?

if camera and base are within a few feet of one another does it have a problem obtaining a signal (syncing ) ?? as if it works ok then there might be a object that is getting in the way of the signal , radio waves move from its transmitter (camera) towards its receiver (monitor) in a straight line , if there is too large a mass in the way then the radio wave can't penetrate it and will be "lost" also ck both the camera's and bases battery levels (if they have one) for proper peak power level , as it takes energy to drive the radio signal towards its receiver .

I just barely had this problem and was able to figure it out.

You need to hit the "ok" button on the side of the handheld monitor. It will only let you select "add camera".

Hit ok again and it will give you a list of 4 camera's.

Now at this point you will need the actual camera and handheld monitor. You need to hold down the "code" button on the back of the camera and select "camera 1" in the list of 4 cameras. This should sync it back and you should have picture again!

I hope that helps :)

Hi,

You can contact our baby monitors department for better assistance.
http://www.motorolacordless.us/

Best Regards,
Katya
Motorola Support

James

Try https://motorolamonitors.zendesk.com/hc/en-us

Mark
Motorola Support

I just barely had this problem and was able to figure it out.

You need to hit the "ok" button on the side of the handheld monitor. It will only let you select "add camera".

Hit ok again and it will give you a list of 4 camera's.

Now at this point you will need the actual camera and handheld monitor. You need to hold down the "code" button on the back of the camera and select "camera 1" in the list of 4 cameras. This should sync it back and you should have picture again!

Guys anyone having issues with Motorola Baby unit 'Not Linked' on the fb unit go to the register menu and ans press OK, then you go to the video monitor and hold your finger on the VOL up arrow and they will sync.

Hope this helps

you need to power on the monitor. second, push the power button so you see the list of camera numbers at the bottom. third, scroll over to the camera of choice, fourth, press and hold video on and off button on top of monitor. when red light begins to flash press the code button on back of camera so green light flashes. will sync from there..... best of luck.... any further problems feel free to email me [email protected].... i wrench on and build these exact systems and more for a living

Turn on your monitor and camera. Click the menu button and choose, add camera. As soon as you do, push the "code" button in on the back of the camera. You should see a picture soon after.

The transmitter and receiver should sync up easily. Mke sure you have both of them set for either channel A or B -- it doesn't matter which one as long as they are the same.

Did that fix it? If not, another device may be interfering. Do you have one receiver or two?