Samsung HLR6167W no picture/no sound

All three LED lights flashes,u hear alot of clicking sounds too?Yes,ur tv the Ballast board is dead too.This Ballast board job is only to ignite the tv projection lamp only.Replace the Ballast board,should solve this problems.

Sounds like your color wheel is busted...

This was not an expensive part nor too much of a complicated process on my hl-r5067w (see here: http://mistermarbles.blogspot.com/2008/04/replacing-color-wheel-for-samsung-hl.html), but you'll need to figure out part source and process differences on yours.

Good luck!

here is this could wrokhttp://www.ehow.com/how_5535314_reset-lamp-hours-tv.html

I suspect a Light Engine problem. I would call a service company for that particular problem.

sounds like you need a new lamp

You need to do an aggressive reset on the TV. This solved problem completely for me. You must unplug the TV when it is on. Repeat this several times until the TV is jolted back into the factory default settings. The issue is actually with the programming I believe. The clue was that the display worked 100% perfect in HDMI mode, and the problem only existed in the cable setting, no matter if wires were attached or not.

Again, do an aggressive reset to the TV by unplugging it several times while it is on. It may not register the reset at first because after all, the actual problem is a programming issue and it's having trouble recognizing commands in the first place.

Good luck!!

Replace the main pcb

Does the TV appear to be cycling on and off, like its attempting to boot up? Or, does it just not come on at all? Don't miss the lamp door interlock switch. Many Samsung DLPs have tempermental door switches. Try re-installing the door or manually hold the switch in the closed postion and try to power it up. If the lamp comes on and stays lit, you've found your problem.

michtech

Tis dead - trade in time - buy a samsung with 5 year warranty and get some sleep...

replace the color wheel