Power out when running. showed code F 71 now not working.

Question edited for clarity.

When the power came back on, or when it went out, there was probably a brown out or voltage surge. You need a service visit. You can try and claim against the utility company for not regulating their power supply to you. Are you certain you have power at the outlets? It is odd that both would succumb to it, unless you were hit by lightning?

check there is power to cold water solenoid and that is working

Good Morning Friend,

I understand that your Frigidaire Affinity washer, model# ATF7000E, is flashing an EFO code. I do not show an EFO code for your appliance.

I do show an EF1 code, which means the drain pump is clogged. In this instance you would unclog the drain pump.

I also show an EF2 code, which means too much soap was used. All you would do for this would be to try using less soap.

It could also be a false error code. I suggest resetting your washer, by either unplugging it or shutting the power off at your homes circuit breaker, for 3-5 minutes. When you restore power, start any cycle on your washer. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your washer status has changed successfully. Hope this is helpful.

-Best Regards-
WP

This confirms that the main power supply which is the SMPS is faulty.
The fuse could have failed and must be checked, if the fuse fails the SMPS is confirmed to be faulty due to the power outage.
please check the links below for tips and support:

http://www.fixya.com/support/r5826301-working_switch_mode_power_supplies

http://en.wikipedia.org/wiki/Switched-mode_power_supply

Hate to say this, but when power outages occur, things like vcr's are the first thing to fry. But if you feel that the vcr is fine as far as powering up, then unplug it from the wall socket for 30 minutes or so, plug back in and see results.

try reseting the clock as lots of ovens will not work untill clock is set

My Bosch washing machine shows error code F57 and beeps

no but there is a control bd it is probably gone

Try unplugging the unit for 30 seconds then plug it back in. The power outage may have been erratic and the MW did not reset properly.

I had power outage last night now corder at&t 1855 led's keep flashing keeps telling me about power outage before every new message. How do I get rid of the flashing?