Can't connect nerf ps2 controller to its receiver.

Observe these instructions to connect your wireless Logitech PS2 controller to the receiver :-

1. Verify that the PlayStation 2 console is connected to the receiver.
2. Switch on the PlayStation 2.
3. Replace the controller's batteries.
4. For roughly 2 seconds, press and hold the receiver's sync button.
5. Press and hold the controller's X button for 5 seconds.
6. To verify a connection to the receiver, the controller LED should flash rapidly.

Try the following if the controller won't connect :-

• Double-check the placement of the batteries.
• Experiment with various batteries.
• Bring the controller up to eye level with the receiver. Try rebooting your PlayStation 2.

Try getting help from Logitech customer service if you're still having issues attaching the controller .

Here are some extra pointers :-

• Verify that no other controller is currently using the receiver.
• Verify that no other wireless devices are present that could interfere with the connection.
• You might need to utilise an adaptor to connect the receiver if you're using a PS2 Slim.

Most wireless controllers have a switch on both the sensor and controller which allows you to select a channel, useful for when you have more than one wireless controller. If yours has such a switch, make sure that both the controller switch and sensor switch are on the same number channel.

no may ne u need config it manually

Well what do you expect from nerf to make a game controler :S. Buy a regualr logitech or Sony ps2 controler.

Hope this info helps!

Here's the link to the Pelican website with a pdf manual to download.
http://support.pdp.com/ics/support/default.asp?deptID=5553&task=download

mabey your not doing it fast enough

take batteries out control and put back in...turn off ps2 and while holding the button on the ir piece connected to ur ps2..turn it on and dont let go till game has fully come on...should work..if the red controller light still keeps blinking after doin it a few times then change your batteries

Plug-in the receiver press the button then place the batteries in your controller, press X and done. This worked for me

Hi Rayjdawg,

Check the battery pack on the back of the controller. It's been known to not have good contact at times. I would also try changing the battery. Good luck. :)