HOW TO CALABRATE LASER LEVEL

http://www.crescenttool.com/crescent-lufkin-measuring/tapes

I don't know why they did this, But other manufacturers are going this way. The consumer can't check the transmission fluid. They have to go to a shop. You can get the stick online. Yours at operating temps are 16 to 17, or 160 to 170, depending on the stack you get. The stick is cable with a metal piece on the end. Push it down until it bottoms out. If you shove it to far/ force it. You have to remove the oil pan to get it out.

Asking Lufkin is your best option as they might repair or replace for free or low cost.
The Official Site of Lufkin Brand Measuring Products
There are videos out there that will show how to take tape measures apart. However it can be tricky and if you are not careful the whole thing can become a mess to deal with. Most companies will not offer repair or replacement if you have tried to fix it yourself.

Hi...sorry for the bad image but if you can make it out ...this tape measure is offered in two types of measurements either Feet/Inches/Eighths or Tenths/Hundredths ...if your father's is off by an inch my guess is that the Lufkin is measuring in Tenths/Hundredths.

Hope this helped!

Here is a better look: http://www.cspforestry.com/Lufkin_1_2_x_100_Hi_Viz_Orange_Fiberglass_Tape_p/lufkin1706.htm

You need to take the screws out of the side but you may have broken the spring recoil mechinasum you can get a new tape but if the recoil is damaged its not worth fixing it would coast you more then buying a new one

Buy a new one.

maybe the touch screen is defective. did you drop the DS somewhere?

if you do the calibration REALLY fast, it may be able to correct the problem

flot problem

Dear,
Use the smart panel utility from Samsung website or from the CD to adjust the color density.

Regards

You need to clean the scanner. You can try doing the shading adjustment to calabrate the scanner but most likely the mirrors are hazed up. Since you can print fine you eliminate the laser.
To do the shading adjustment, you need to press in order,,, Menu # 1934, You will see a " T "on the screen, that will be the tech mode. Press the machine status, then go to maintenance, then scroll to shading. Place 5 sheets of white paper on the glass and then run the shading adjustment. turn the machine off and on, and run copies again. But most likely you will have to take the scanner off and clean it.
If you want to clean the scanner let me know, I will send you directions on how to do that. The mirrors in that scan head tend to haze up.