Whirlpool Ultimate Care II LSB200KQ1 Top Load Washer - the washer filled and then stopped. No humming, no sound, no action when we turn the knob. Thoughts?

Sounds like a lid switch problem

is the water on to the washer,if water on may your fill screen are clog up with dirt.are you good have a bad motor

sounds like your lid switch is bad or possible timer

Agitator dogs, I go through a set every 2 months. It has gotten so I can replace them in 3 minutes.

Under the tub is a round coupling that wears out. This needs to be replaced. When the washer is over loaded it puts to much stress on this coupling and wears it out. You have to take out the drum to replace it. As for it not filling, check the water vavles that supply the washer they may have been turned off

Lid switch. Push down on lid.

i would make sure the water valves are turned on, the first thing the washer wants to do is fill. the humming noise is probably the inlet valves opening.

sounds like you have a bad lis switch asm.

you could have a broken mtr coupling

If you open the lid, does the humming stop? If so that means your lid switch is good, the hum is from you motor, which means your transmission is messed up. You need a service call.

Sgt 48