Looks like the water pump is leaking every time it goes through the rinse cycle. Would rather repair if possible because this is only the 2nd breakdown in 25 years.
SOURCE: Fisher Paykel GWL11 Top Loader Washer
Please dont put any more money into this machine,if you wait long enough it will take alot more than a penny.
SOURCE: Fisher & Paykel "clog Problem"
the water comes through 2 vavle 1 for washing and the other for rinsing more than likely that the rinse valve is down it will need replacing thats the more common fault for washers not rinsing
SOURCE: Fisher & Paykel Washer Model GWL11
Clebinla,
I have the same problem with our GWL11. It just started yesterday. I think I found out where the problem is occuring. I noticed that there seems to be a crack in the small rubber tube that supplies the fill water. The water leaks out of this crack and runs down the back of the machine. I fixed the problem temporarily by putting a piece of plastic below the cracked tube that funnels the water into the tub. I am trying to locate a replacement for the tube but I haven't had much luck yet (it is a curved yellow tube that is a couple of inches long.)
SOURCE: Fisher and Paykel GWL11 Question
no belts ..direct drive ..lean washer back pump is a twist lock no tools needed hose clamp can be removed with fingersremove pump and ck for lock impeller also ck the diverter valve just behind pump
SOURCE: Fisher and Paykel GWL11 will not drain...
Dear friend,
ngfam at you service!
You can not fix this problem your self!!!
This sounds like it will only fixed by service then you will be happy again!!
Yes sounds like you need service!
Call A&E Factory Service /They service nation wide
And are available 24/7 for making appointments!
Happy to assist you,
PS. PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!
524 views
Usually answered in minutes!
My apologies - my machine is actually a GW52F Fisher and Paykel Wahing Machine
×