BRAVIA KDL-V32A12U PICTURE LOSS

SOURCE: TV turn on and off

Your TV has a power problem, it maybe high or low supply voltage that causes the TV to turn it self off because of an error. A technician from the manufacturer knows what error it has just by looking at the flashing standby light. Best is to take it to an authorize service center for repair... ^_^

SOURCE: Flashing Standby Light (6 times every 2 second interval)

A 6 flash error indicates a problem with the backlight. Your set is less than a year old and still in warranty, so you should contact Sony and arrange for a service call to get it repaired.

SOURCE: tv bravia kdl 40v3000 problem turning on

Hello,

Unfortunately, this is a failure of the balancer board for the backlight. The unfortunate part is that the balancer is not available by itself anymore, and the whole panel must be replaced, as Sony only has the balancers attached to new panels. You can contact Sony directly to ask for assistance, and it usually helps.

Hope this helps you...

SOURCE: Have a new Sony Bravia

Hello,

There is some confusion on the model (KDL-40W500 vs. KDL-40V2500), so I will direct this toward the 40V2500.

On the KDL-40V2500, an 8X blink means the scan processer has gone bad, and the BU board needs to be replaced. If the problem is intermittent, the the AU board might be the problem, but if it all the time, bank on the BU.

A competent repair shop should be able to help you, or you can try calling Sony directly for assitance.

Hope this helps you...

SOURCE: Sony Bravia kdl-46S3000 flashing red lights

Sounds Lamp is weak in this TV.
Please replace lamp and procedure is written in TV user manual.