MY PRINTERIS HP D 1360. NO PAPER PRINT.I HAVE NO KNOWLEDGE OF TROBLESHOOTING. message no toner. but new cartidge.

the problem is in fuser or in toner cartidge.
print a page when the printer start to pull the paper more than a half page stop the printing by open the door
remove the toner and look the paper
if you see the line the problem is from toner replace toner cartidge if you see the image ok means the problem begins when the paper go into the fuser so replace fuser.

sounds like might be your toner, specifically your black toner.
is this a non-standard toner or HP? IF it your toner you can try this:

Place a stip of opaqe tape or paper or the chip. When the printer detects a non-standard cartridge press the green (go) button. It will then reset the LCD to Ready.

Found this info on a recycled manufacturer site. http://www.infinityimaging.com/cgi-local/SoftCart.exe/online-store/scstore/p-2300.html?E+scstore

otherwise it's probably the memory on the printer, try removing or replacing a DIMM

yes buy new cartidge

or clean drum charger roller

If it is up and down, then you have contamination of the paper path. The paper path needs to be thouroughly cleaned.

In addition, check the rollers and little wheels that keep the paper flat where the printheads cross. On some printers, the carrier for the shaft of these can come loose and allow the paper to buldge up slightly to hit the print head and smear a vertical stripe.

Replace the toner cart. immediately

Take printer outside and blast with air from small low-pressure compressor.

Toner is very messy, but harmless

Reaseat toner cartidge again :)

I have the 1350 all in one, and when I changed my cartridges I screwed up and replaced both at the same time, that was a no no as I found out. I kept getting the test printer and print example too. so what I had to do was Uninstall the printer and drivers, then reinstall them again, that worked.

The average yield for a Q2612A cartridge is 2,000 standard pages.

Based on these statistics

Current I don't see a higher yield cartridge available for your printer. The company I work for only carries 2,000 yield as well.

Did you swap toner cartridges into this new printer?

If this is a new printer make sure all the packing material is out of the cartridge slot such as any tape, seals, or string.

Your printer should have come with instructions telling you where the packing material is.

1-remove power from fax.
2-clean contact points in toner cartidge and the contact in fax which it make contact together.
3-knock above toner cartidge many times.
4-move it in horizontal direction from left to right many times.