I have checked the inlet water valve and water is not making it pass the main valve. Will replacing the water inlet valve fix the problem or is it usually something else?
As per my email reply chazmano5, the problem is likely to be the water pump/motor assy.
They have a very common fault of the impeller breaking on the motor shaft. The motor still spins, but the impeller doesn't, so there is no water being pumped.
The machine senses there is no water pressure and shuts down, displaying E1 (eg: it thinks no water pressure means there must be a water leak) Unfortunately the motor/impeller is only available as a complete assembly.
910 views
Usually answered in minutes!
Take a good voltmeter and check resistance using Ohms. The measurement should be between 800 1200ohms. Mine showed infinity meaning its crapped out.
YEs inlet valve is bad, replaced and now recieving e1 error code. I believe b/c the motor is spinning up too fast.
do you know the part number to replace the motor for this unit? Would i need to replace the impeller too or just get the whole assembly?
×