The touch screen will turn on when you touch the screen and acts like it's going to boot up but does not finish, it flashes and then turns off. The other buttons work except the stop button.
SOURCE: Pro-Form Sport 1000 treadmill does not stop inclining
Do a Calibration on the treadmill. Take out the safety key. With 2 fingers, hold down the stop button and the speed up or spped plus button. keep holding them down as you insert the safety key, then let go of both.
Press the stop button 1 time, you should see all 0's in the windows, or EP 2P or something weird like that.
Press the Incline up button and then wait. If the incline go up until it stalls then down until it stalls the stops at the bottom, the you are recalibrated, take out the safery key and put it back in to see if all is well. If the incline takes off up again without touching a button, the you have wiring problems or control problems. Call service company to get it repaired.
SOURCE: My treadmill comes on, but the control panel is
you req a new pcb (control board) look up your model number on google for spares .
SOURCE: Buttons don't always want to work
If the console takes batteries, replace them. If this does not work or your console does not require batteries, check the reed switch or optic sensor. Reed Switch: Unplug the treadmill and remove the motor hood cover. The reed switch is mounted on the frame next to the front roller pulley. There is a magnet glued into the front roller pulley. When adjusting the reed switch, make sure it is pointing directly at the magnet. Move the tip of the reed switch within 1/8" of the magnet. Also, check to see that the wire is not damaged, and is connected to the console.
Optical Sensor: Unplug the treadmill and remove the motor hood cover. The optic disk and sensor are located either at the end of the motor or the right hand side of the front roller. The optic disk spins between two sensors on the optic switch. The disk must spin freely without touching either sensor. The sensors can be moved by loosening the adjustment bolt holding the switch to its bracket. The switch can then be slid. Center the disk.
See the diagram for 1/8" or 3mms aprox. and clean up very well.
Attached is a Block Diagram for purpose to teaching people like you,that I did to show how the Main Controller has aprox 90% of functions of the treadmills.
You must clean the keypads with contact cleaner (spray radio schack or computer store) and then tighten the flexible cable to Display Board and then Connector from Display Board vs. Lower Boar( Main Controller Board) very well.
Good luck,sincerely.
E.CUADRA
MANAGUA, NICARAGUA. C.A.
1,372 views
Usually answered in minutes!
×