Software problem I have re installed disneypix 3.2 twice and repaired it countless times but every time I try to open it there's a message saying there's and error and that i should be able to restart the program. I have tried countless times but nothing. The software opens but then it gives me the same message. Its not working.

SOURCE: Lense won't open.

There is a very small lens inside the camera which moves back and forth to focus the image. Sometimes this lens gets stuck making it impossible to focus the image. If this is the case a nice firm smack on the palm of your hand can jar it free. I know it sounds crazy, but it has worked for me before.

SOURCE: imation atom usb driver vista

vista has this problem , see below webite

Error message when you try to install a new hardware device on a Windows Vista-based computer: "Windows encountered a problem installing the driver software for your device GET basis information
http://support.microsoft.com/kb/940199/en-us

SOURCE: corrupted files on cruzer micro 4gb

Due to the U3 technology, i.e. the files you deleted which were on the drive when you got them, you may have caused the drive to malfunction because the U3 software was not uninstalled, but rather deleted.

Please attempt to reinstall the U3 software on the Sandisk website, named "U3 Launchpad Installer"
which can be found at this link: http://www.sandisk.com/Retail/DriverDownloads.aspx

If you are still having problems, either reinstalling the software or with corrupt files, please report any errors exactly as you see them.

SOURCE: Blackberry Bold 9000 Error (Reload Sofware 507)

Hi i have got a Blackberry Bold 9000. it isn't open. it's error message is
Reload Software: 507
i try to install software with desktop manager but its isn't open when bold
restarts and said same error.

SOURCE: programming keyless remote

2003-04 Mazda 6 REMOTE PROGRAMMING


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the driver’s door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!

Good Luck.