Speed on vsx 7000 appears stuck at 64k

Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If the voltage is absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/

Pls can you ellaborate more on the problem...

There should be some loose solder terminals at its main power regulator section. Resolder all the suspected solder terminals there, by applying a little more solder. Check the solder terminals at the horizontal output stage too. The fault is with loose solder terminals itself.

Thank you

No, you do not need to subscribe. Are you sure your a/v cables are connected properly? You might also check on your video source and make sure you are in the correct source.

You need to go into the audio settings via
Admin Settings
Audio Settings
and make sure Enable Polycom Microphone is checked off.
Reboot and see if your microphone is recognized.

It should say the IP network is up because you say it's on the network. Please clarify your second question?

If you asking for the manual option of ISDN and IP, then got to call preference and change the dialing method to auto

Check out the following things:-

1. When dialing a ISDN number, be sure that the call preference has not been set to IP H.323 on the home screen just below the dialing field.

2. Check with your service provider that outwards dialling have been enabled on the lines provided to you.

I've just solved that problem in the VSX 7000 of my girlfriend's Job.

Your VSX7000 has at least 4 video outputs, 1 for VGA and Supervideo 1 and Supervideo 2.

Firstly you should try VGA connector, because the main menu may be there, so you could change the configuracion.

If you can't see main screen in any of the output connectors you'll have to use the http tool.

In your internet browser enter the camera IP address, and you'll get the Web Interface of the VSX7000.

It will prompt you for user & password, the default options are "Admin" and your VSX7000 serial number (14 digits) you can find this number under the camera.

Once you're in the Web Main Menu, click on Site Map. There you can choose what you want to see in the screen of Monitor1 (My menus are in Spanish, maybe your menu says something like "screens" but I'm sure you'll find it)

If you choose Monitor/Screen 1 as Svideo, and select it as output for Local, Remote and Content you should see the Main Menu after the VSX7000 Reboots.

I hope it would be useful for you, if you have any problem with this let me know... This VSX7000 is working fine now, so yours should work!