Switch on the radio and the display will show 'C'. Press the P1 button followed by the station increment button until you reach the first code digit. Press P1 again and follow the above procedure until the last digit has been entered and finally press P1 once more. The set will emit a confirmation beep from the speaker and will begin to operate.
Hi
The stereo in the Eclipse can be removed with nothing more than a Phillips screwdriver
Disconnect the negative battery cable from your Eclipse's battery. Remove the two Phillips screws along the bottom of the radio/climate control trim panel. Lift up the bottom of the trim panel to unlock the lower retaining clips. Work your fingers around the sides of the panel to loosen the other clips and remove the panel. Remove the four Phillips screws holding the stereo in place. Slide the stereo out of the dashboard and disconnect the wiring harness and antenna cable from the back of the device.
Also check this link if it helps:-
http://www.ehow.com/how_5938157_remove-eclipse-car-radio.html
140 views
Usually answered in minutes!
×