There is a message ( system error ), how to solve this problem ?
E100, means that you need to change whole drum unit. Use genuine from canon.
Please give the more detail of your problam . but system error is showing because of bad configration solve it
OK so yes the Drum unit has a flag on the rear left (when holding it as though you were going to install it). If that is missing you will get an E100. The real meaning of an E100 is a laser beam detect error. So if the shutter doesn't open when you install the drum unit then yes you will get this code. if the drum unit has the flag then there is a deeper issue. Could be the laser or the DC controller.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/charles_45d8d6c78cd9f0b6
Yes, and to add some other tip, it happenned to me to find out the plastic articulation BELOW the laser unit, broken and out of position! Result: even if the notch on the drum is intact,the movement is not transmited to the Laser shuter.
I just removed the laser out and put adhesive tape to the shutter (permanently activated) and Bingo!
×
SOURCE: canon IR 2020 showing system Error E007 printer
my canon ir2020 is displaying system error E007
SOURCE: Canon IR 1600 error message
Note: To reset E000, E001, E002, E003, go to service mode 4. select SET, go to "#7 PRINT-ER," in service mode. Then press Execute "#4 PRINTER RESET." Power the unit off/on.
2,321 views
Usually answered in minutes!
Erreur System E004 and E000
system error
E000
×