Can't get my CAP buttons to work

press Feature *0 (button inquiry) then press the intercom key.

When a set is installed it automatically gets an intercom #

You can forward an extension that is not used at all, and has the lines assigned to ring that you want to forward to an outside number. In programming have the extensions set to forward on busy to the external number using 9+ the number desired. When you leave for the afternoon, take the handset off the phone, and replace it when you return. NOTE THIS EXTENSION MUST NOT BE USED BY ANYONE -- IF THIS EXTENSION IS BEING USED AND A LINE RINGS IN IT WILL BE FORWARDED OUT.

Is the button still programmed?
Do F871 in meantime....F#871 on older systems helps too or just F87.

Program button:
F*3
button
Feature
871

There's a powersupply for that CAP. Often it's in the telecom room. Chances are it's busted or unplugged.

For external numbers press FEATURE *1, then press the button you want to store the number on, then enter the phone number using the dialpad.
For internal numbers press FEATURE *2, then press the button you want to store the number on, then enter the extension number using the dialpad.
To determine what is currently programmed on a button, press FEATURE *0, then the button to identify and the display will show what feature or autodial number is programmed on the button. If the button is a line button or line pool button, you will not be able to clear it through user level button programming. System level programming must be accessed to change line appearances.

The buttons will all have to be reprogrammed. Try this:
Press "Feature * 2", then press the button to be programmed, and enter an extension number. You will have to do this for each button.
Alternatively, you can unplug the phone for 1 minute, and plug it back in. The lights will start to flash on the phone, and stay solid on the KLM. When the lights begin to flash on the KLM, simultaneously press the bottom 2 buttons on the left-side and the bottom 2 buttons on the right-side of the KLM. This will cause each button to light momentarily from the top-left to the bottom-right, and will program the buttons, in ascending order, automatically from the first extension in the system until it uses all available buttons on the KLM.
Hope this helps!

sounds like the programming for that button was changed to last number redial. To re- program the button, press feature *3, press the button labeled transfer, and press feature 70 (transfer).

We actually dug up a copy of the SAPS module install card from somewhere on our premises. No further assistance needed. Thx.

sounds like one of your buttons are stuck. look over the buttons to see if one is a bit uneven or take each button and jiggle it outwards

You need to go into main programming of the system, and set the phone to access those lines. First ID the 2 new extensions. Do this by going to the phone, and pressing the Feature Key "Button with a little black globe", * and 0. then press the intercom button. This will show you the extension number. Press release "Red button with the phone and arrow downward". Then Press feature key "Button with the black Globe" "**266344" and again "**266344" go to terminals and sets. next to the buttons, you will see triangles , 3 for a while and 4 some times. The keys just next to them are your scrolling and enter keys. Scroll to "Terminals and Sets", press the enter button "Top right triangle" and enter in the extension and enter. then scroll to Line Access, enter, line Assignment. For each line, you have to change it to either Appear and ring, appr or unassigned. Set to appear and ring or appr. Do is for each extension to want to have acces to those lines.