Fabric Softner Drawer

Remove drawer/ look inside opening of washer ( at the top of opening inside) there is small little holes for the water to come through to fill the fabric softner spot and also bleach spot and detrgent spot. Holes may be pluged use a old tooth bush or some item to clean holes..Hope that helps thanks for voting.

fabric conditioner drawer is always full of water This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

This is usually because the fabric softner draw is prone to colgging due to a build up of gunk in the holes that drain the softner into the machine at the appropriate time. Remove the drawert (There is usually a thumb press release at the back of the drawer you will see if you pull it out as far as you can.
After removal, wash the drawer all over (paying particular attention to the bottom of the drawer). If you have a garden hose, take the drawer outside after you have cleaned it and turn the hose on, full belt, and blast out all the waterways in the drawer to make sure they are clear. Refit the drawer and this should sort out the problem

that is normal you can either add water to make it drain or pull out the drawer and dump it.

strip and clean out the soap tray then remove the tray and clean the fill water holes above it with a stiff washing up brush.

Remove hoses from fill valve, clean screens inside fill valve, if this does not fix problem, replace valve.

Pull the drawer out as far as it will come and then grasping it firmly, give it a good tug towards you, this will free the drawer to enable you to thoroughly clean every piece of it, particularly the conditioner parts of it.
Get a piece of wire with a bend on the end, and poke it in to all the holes in the top of the dispenser compartment, this will clera any blockages there.
Plz rate my solution, and feel free to leave any comment.
Thanks.

take the soap dispenser drawer out and clean the drawer and the underneath the drawer, then clean the inside of the machine where the drawer fits into to. It could be caused by a build up of soap.

hi there are you using concentrated softner if so water is down as some softners are to thick to go through the dispenser also give the whole drawer a soak in hot soapy water incase there are any blockages.

hope this is of some help

I think you have something stuck in the fill hose.. Remove the top two or three screws in the back.. then pull out the hose that goes to the tub. I bet you will have something in there.. most common is the inside liner to a bleach cap..let me knowif this it it... krazytech