GE XL44 Gas Range Clock Display frozen with only an "8"

Didn't give a model number, but try the following:

For a mechanical clock, push the center knob in and turn the clock hands to the correct time. (If the Minute Timer pointer should move also, let the knob out, turn the Timer pointer to OFF.)

For a digital clock, push in the center knob of the Minute Timer and turn Knob in either direction to set the Digital Clock numerals to the correct time.

For an electronic clock, touch the Clock pad. Touch the number pad. Touch the start pad until the time of day shows in the display. Note: On double wall ovens, you can only set the Timer for one oven.

(From the GE website)

Clock & Main control display issues - YouTube

? 4:44
https://www.youtube.com/watch?v=OmOocInxHOo
Jun 28, 2013 - Uploaded by ApplianceVideo.com
... symptoms: Clock and display does not work At: http://www.appliancevideo.com For ... and show you how to ...

Range/Stove/Oven Repair - Replacing the Clock Timer ...

? 3:42
https://www.youtube.com/watch?v=0RSnf4wfSZM
Oct 20, 2011 - Uploaded by PartSelect
Range/Stove/Oven Repair - Replacing the Clock Timer (Frigidaire Part .... My timer still works fine, but ...

Y0315570 Amana Range/Stove/Oven - Appliance Timer

Hello steve o - Typically error code F11 indicates a shorted keypad. Try resetting the range by unplugging it or flipping the household circuit breaker off. This usually will clear most false error codes. Wait approximately ten minutes and if the error code does not clear contact a professional to move forward accurately. Most likely the EOC on the range will need replacing.

This is a failure with the clock module. You can replace it with a new one, or fixyourboard.com rebuild it to save you some cost.

yes it is called a electronic oven control go to ap wagner.com and enter the model number and you can get priceing

We see this failure due to two possible problems with the electronic control. Sometimes there is a failure that causes the display to shut off. Other times the display itself goes bad. The first case we can repair. If you send us the board we can check it out. If it is not repairable there is no charge. - www.fixyourboard.com.

bad clock board

you have 1 of 2 problems. your range is either in sabbath mode or your clock control is bad. if you have your model number i can get you directions to see if it is in sabbath mode. unless you have your user manual

You can replace the clock. Apwagner.com.

The plug on your range may not be completely inserted into the outlet.
Clear all functions and see if the clock unfreezes
After all this, if the clock digits light up, and you still can't use any clock functions, it may be time for a new control panel.