Car location of ecu socket

16 pin only

all 1993s its above drivers left knee.
its below ECU
its green socket.
its the only relay with a PINK wire.

why not post symptoms.???????????
are we only a FSM that talks?
click early relay location here.

http://www.fixkick.com/INJECTORS/depressure.html

old post but im flooding geo posts
so other can search and find answers for this rare old car,
there is no switch
only a relay , actually 2 relays.
one is fuel realy in green socket below ECU and
other is ecu mAIN, next to above in black sockete
if either fails, car will not start
they are same p/n so can be swapped.
if CEL glows in cluster key on, main is ok
are FI and IG coil fues good at left top knee?

no start, just for this car alone.
http://www.fixkick.com/nostart.html

HERE
http://www.fixkick.com/INJECTORS/PUMP/Fuel-Pump-Relay1w.jpg

IF THE PINK WIRE GOES TO 11 TO 12 VDC CRANIING
ITS NOT THE RELAY
IF NOT NEAR 11V, THE ECU IS BAD OR IT HAS NO POWER.
FUSES BAD TOPS LIST
THE FI FUSE MUST BE GOOD
IF THE IG COIL FUSES IS BAD THE ECU IS DEAD, OFF LINE.

The fuel pump relay is one of two relays attached to the brackets holding the ECU. Just above the driver's left leg, up under the dash, near the fuse box. If I Remember Correctly it is green or has a green socket.

Different make and model of cars have different location for it ECU however i most case the ECU is located in the passenger area or engine bay. If it is in the passenger area, most likely it is behind the radio in the center console or behind the glove box.

Do not leave key in ignition while doing this! First get the hood open and disconnect the battery from positive side. All doors closed lock or unlocked dosen't matter. Wait about 2-3 min.carefully reconnect the positive cable and tighten,car should go into combination of locking modes.Next your key push one time lock and hold unlock for 2-3 seconds or push the unlock twice.Locks should function properly lock to unlock and reversed.Normaly this resets all electronics to ECU.

if you want to replace the pcm you will need to program the pcm/ecu to communicate to other cumputer system, it is located at the right front side of your car, inside the front bumper, you need #7 and #10 socket wrench, lift the vehicle fror easy access

i think it is under the dash at the side passenger

2005 kia sedona ecu is located on passenger floor under carpet. After you remove the carpet half way, there is a silver plate you have to remove with 10mm deep well socket. there are 4 connector plugs.