Close tray error when printing.

Hello,

the error message means there is something wrong with the printer and if the problem is not attended to, the error message will not go away.

In this case, the error message showing on your canon ip4300 is related to a door problem. It has something to do with the front door of your printer. I think the front door of your printer is closed of which is supposed to be opened.

So, the solution is to Open the paper output tray of your printer and the problem should be solved.

Good luck.

Hi, please get new driver here: www.driversdown.com/
www.nodevice.com/driver/company/Canon/Printer.html
www.usa.canon.com/cusa/office/products/.../hs_1200ts

Jay hbvgck

Then you close the tray so that it will continue printing. That is a warning that you should close the tray so that the printer will work properly.

Try keeping the paper only in the bottom tray (there's a tray in the bottom) Try pulling any paper out of the top and just close that top tray. Open up the head so that u can see the ink cartridges and turn the printer on and off and maybe it will center itself again. If it's still not working (even if lights aren't red and print head wont align in the center) try manually moving the head back and forth like 18 times so you can lubricate that rail in the back that's holding it. After that, re-turn it off and on again.

remove all supply and then plug then attach data cable, uninstall printer driver and install again

The micro switch on the door may not be working. You need to fix it or replace.

Reset the device when it is not functioning properly. If the device is not functioning properly or to clear memory, reset it.

1. On the operator panel, press and hold the <ON/OFF> button for one second. (The display will go blank.)
   
   Note: It may be necessary to unplug the power cord if pressing the ON/OFF button does not shut off the printer.
   
   
2. Wait approximately ten seconds and then press the <ON/OFF> button again.
   
   
3. Wait until the device has completed its cycling process before submitting another job request.

Closing the inner cover to clear error messages.

1. Raise the Scanning Unit until it stops.
   
   
   
   (A) Press the Open Button to open the Paper Output Tray if it does not open automatically.
   
   
2. Close the Inner Cover
   
   
   
   
3. Close the Scanning Unit.

I hope it helps!!!

i have a pixma ip4300 i keep getting the error number 1250 "paper output try is closed" but infact its is open i have tried opening and closing and restarting and everything else i can think of. any ideas of what to do?

Sorry a little late only just read your problem.
The location is not the bottom tray feeder but the disk tray. In settings change your media type to "Printable Disk" the paper scource should automatically change to "Disk Tray" and hopefully every thing will work OK.

there is a small,square button near the right,front corner. think of it as the button for the refrigerator light. It must be depressed by the closed top or maybe something to wedge it down. Duh