SOURCE: I am looking fore the uverse remote code for naxa
i install uverse, the auto seek is done by hit and hold TV and OK. wait for lights to flash enter 900 and push play over and over SLOWLY and when the tv turns off, press enter.
NOTE: some tvs WILL NOT program to our remotes
SOURCE: Need a NAXA remote code for dish network Remote
Hopefully you have resolved this issue, but if you have any additional problems or questions, here is some help. Follow the directions below, and that remote will be programmed right away.
1. Hold down the Clear TV button until all lights at the top of the remote light up
2. Press the red TV POWER button
3. Press and release the up arrow on the remote about once a second until the tv turns off.
4. When it turns off, press the # (Pound) button
5. Try powering the tv on/off, and try the volume. If one or more of these functions do not work, start over at step 1 again.
Becki Barned
DISH Network Customer Service
109 views
Usually answered in minutes!
×